Honeywell – 802171 Fixed heat detector IQ8Quad

Automatic heat detector with a single thermistor to sense the air temperature around the detector. Fast semiconductor sensor guarantees reliable detection of fires with strong heat generation. Ideal for sensing in environments that are dirty or smoky under normal conditions, as well it is unaffected by wind or atmospheric pressure. Intelligent fire detector with decentralized intelligence, automatic function self-test, CPU failure mode, alarm and operating data memory, alarm indicator, soft-addressing and operating indication.

The detector is provided with an integrated isolator. A remote indicator can be connected.

Features & Benefits:

Automatic intelligent fire detectors with high reliability and low power consumption used for

premises and items of property with medium and high concentration of valuable assets

Detector Series IQ8Quad features, system advantages

Designed for optimal operation on System 8000, IQ8Control and FlexES Control fire alarm

systems

With multisensor fire detectors for the detection of all types of fires, even under the most difficult

operating conditions and with 360° LED visibility in Alarm

Detector with and without loop isolators

Different options of installation

Wiring in loop and spur combination

Maximum number of detectors with cable lengths of up to 3,500 m with installation cable for fire

detection, e.g. cables I-Y(St)Yn x 2 x 0.8 mm

Up to 127 detectors and detector zones per loop installation

Free wiring of display and control elements through software function assignment

Up to 32 detectors per zone

Easy commissioning

Automatic and interactive detector addressing

Fixed address assignment of detector location, even after detectors have been replaced or

added

Localization of wire breaks and short circuits on loop

Detector-LED used as alarm indicator and as an indicator for detectors in service

Adaptation to changing operating conditions

Dedicated LED for indicating operation (green LED)

Disconnection of individual detectors, detector zones and detection areas

Disconnection of individual sensors or several sensors at once within a multisensor fire detector;

either manually or depending on programmed time of the day

Automatic adaptation to varying environmental conditions

Compensation of changing levels of air pressure, humidity, smoke concentration according to the

double chamber principle

Electronic compensation also called drift-compensation of long-term influences like aging or

pollution

Reliable detection

Constant alarm sensitivity of multisensor fire detector for all types of fire

Large signal to noise ratio due to the special design of the sensors and the electronics to

suppress electromagnetic interference

With built-in insect screen and sealed against rear air flow entry

Reliable false alarm suppression

High immunity against false alarms by means of timed evaluation of different sensor criteria

Signal patterns not typical for fires are eliminated by using special filter algorithms

Automatic self-monitoring of detector electronics

Continuous loop monitoring even during short-circuits through isolating the relevant segment

Automatic monitoring of all sensors to guarantee operational capacity and correct condition

Increased operating reliability

Short-circuit and wire break tolerant through monitoring from both ends of the loop

Alarm decision inside detector

Fail-safe circuit activated if communication fails

Maintenance

Automatic maintenance request

Heat detector identification through a black circle on the light transmission plate

Multisensor gas detector identification through a golden ring on the light transmission plate

Operating time-, alarm- and fault counter in each detector

Automatic, cyclic loop check

Complete status interrogation from the control panel

Interrogation of operating data from all detectors on loop via standard service PC and detector

interface

Comprehensive range of accessories

Standard detector base, base with relay and wireless base available

Base adapter for ceiling mounting

Dust cover for fire detector or detector base

Kit for suspended ceiling mounting

Certifications:

EN 54-5

Honeywell ESSER 802171 — Automatic heat detector with a single thermistor to sense the air temperature around the detector. Discontinued by Honeywell — no longer in the current range. PartnerPLC sources new, surplus and discontinued Honeywell parts — request a quote for price, condition and lead time.

Specifications